52古典>英语词典>wedge shape翻译和用法

wedge shape

英 [wedʒ ʃeɪp]

美 [wedʒ ʃeɪp]

三角形

英英释义

noun

  • any shape that is triangular in cross section
      Synonym:wedgecuneus

    双语例句

    • Abstract The calculation methods for the volume of the wedge shape part and the obliquely tangential cylinder of the tilted vertical tanks are discussed.
      讨论了倾斜立式罐楔形体部分及斜切圆柱体部分容积的计算方法。罐底板容积的计算则可不必考虑倾斜。
    • Objective: Hepatectomy of liver segment, subsegment, Wedge shape and liver segment transplantation had been widely developed in clinic.
      目的:临床上肝脏的段、亚段、楔形切除以及肝段移植已广泛开展。
    • Sliding wedge shape and analysis method of global stability of rectangular excavated trenches
      矩形槽开挖失稳滑动体形状及整体稳定分析
    • The damage Mechanism is mainly consisted of plane sliding, falls, topples and wedge shape sliding.
      破坏方式以平面滑移、崩塌、倾倒和楔形滑动为主。
    • The underwater fan brings the reflection configuration: strong top and bottom reflec-tions outlining its wedge shape, top reflections showing overlaps, rare reflections inside and at proximal part, continuous reflections at middle part and weak reflections at distal part.
      其顶底反射能量较强,构成扇体的楔状外形,扇顶反射多有超覆,扇体内部和扇根为零星反射,中部连续性变好,扇端反射能量变弱。
    • This emphasizes the wedge shape, and also allows for enhanced rear headroom and improved aerodynamics.
      这强调了楔形,并加强后排空间和改进的空气动力允许。
    • The analysis and calculation indicate that the image of a square for a wedge prism is in the shape of bell with a convex side rather than with a concave side.
      分析和计算都表明,正方形物体经光楔所成的像是凸侧面的钟形而不是凹侧面的钟形。
    • A sharp wedge shape after-body and tail vortex sheets are added to simulate actual flow.
      为模拟实际流动,在后部加一尖劈形后体,并施出一尾涡面。
    • The study results obtained by AFM suggest that the flow pattern defects were revealed as having wedge shape and there were small octahedron voids surrounded by { 111} which were the same as COPs and LSTDs planes were observed at the tips of flow pattern defects.
      用原子力显微镜对FPDs结构的研究结果表明,FPDs缺陷形如抛物线,并且在其端部存在有和COPs、LSTDs缺陷相同的由{111}面构成的八面体空洞。
    • An improvement on the contour for wedge-shape extruding die
      楔形正挤凹模轮廓的改进